Toshiba Satellite 4030CDT - Changing the Battery; Removing the Battery

Mobile Computing
Changing the battery
To set the alarm levels:
1 Click Start, point to Settings, and click Control Panel.
2 Double-click Power Management.
3 Select the Alarm tab.
You can set each of the levels to the time remaining at which
you want to receive the Low Battery Critical Battery warnings.
You can also set how the warnings occur—alarm sounds, text,
both, or none. You can also configure the computer to go into
Stand by mode or Shut down during the alarm warning.
Changing the battery
When the battery runs out of power:
♦ If AC power is available, run the computer from the AC source
while the battery charges, or shut down the computer and allow
the battery to recharge.
♦ If you have charged a spare battery, change the battery.
CAUTION: Handle battery packs carefully to prevent damage
to the casing. Avoid dropping the battery or mishandling it.
Also, be careful not to short-circuit the battery terminals.
Removing the battery
1 Save your work.
2 Shut down the computer or put it in Stand by mode according
to the instructions in "Using the Stand by command" on
page 39.
3 Remove all cables connected to the computer.
4 Close the display panel and turn the computer over so the
underside faces up.
Part I: Getting To Know Your Computer