Toshiba Satellite 4030CDT - Inserting a Charged Battery

Mobile Computing
Changing the battery
5 Carefully slide the battery release panel toward the front of the
computer.
Removing the battery
6 Slide the battery away from the computer until it stops (about
3/4 inch).
7 Lift the battery module and remove it from the computer.
WARNING: If the battery is leaking or its case is cracked, wear
protective gloves. Discard the battery immediately, following
the advice in "Disposing of used batteries safely" on page 65.
Inserting a charged battery
1 Wipe the battery terminals of the charged battery with a clean
cloth to ensure a good connection.
2 Place the charged battery into the battery cover with the bat
tery's label facing the inside of the battery cover and its termi
nals facing the open end of the cover.
3 Slide the battery release panel in the unlocked position.
4 Without using force, place the battery and cover in the battery
compartment.
HINT: When properly seated, the battery cover is flush with
the bottom of the computer.
Part I: Getting To Know Your Computer