Toshiba Satellite 4030CDT - Removing a Memory Module

Getting Started
Adding memory (optional)
11 Reposition the memory module cover and reinstall the two
screws to secure the cover.
12 Turn the computer over.
13 Reconnect and turn on any peripheral devices that were dis
connected from the computer.
14 If you want to power the computer using AC power, connect
the AC adapter to the computer and plug the power cable into
an AC outlet.
15 Press the power button to boot the computer.
When you turn on your computer, it automatically recognizes
the new memory configuration.
Removing a memory module
The memory module is accessed from the underside of the com
puter. You need a small Phillips screwdriver to remove the
memory module cover.
To remove the memory module:
1 Remove the memory module cover. For instructions, see steps
1 through 8 of "Installing a memory module" on page 20.
2 Gently press the latches on both sides of the memory module
to release the module from the connector.
The memory module pops partially out of the connector.
3 Carefully remove the module from the connector.
NOTE: Do not touch the connectors on the memory module or
on the computer. Debris on the connectors can cause memory
access problems.
4 Position the memory module cover on the bottom of the com
puter. Secure the cover using the two screws removed earlier.
5 Reconnect and turn on any peripheral devices that were dis
connected from the computer.
Part I: Getting To Know Your Computer