Toshiba Satellite 4030CDT - Hibernation Mode

Learning the Basics
Starting again where you left off
Using Resume Mode
Resume Mode provides more options than does the Stand by com
mand. With Resume Mode you can configure your system to:
♦ Automatically stand by/resume when you close or open the
display panel.
♦ TYirn off automatically when you have not used your system
for a set amount of time.
To enable Resume Mode:
1 Press Fn and F3 simultaneously to display the Resume Mode
pop-up window.
2 While holding Fn, press and release F3 until the pop-up window
indicates Stand by.
3 Release the Fn key.
You are now in Stand by mode. When you turn off the
computer using the power switch and then turn it back on
using the power switch again, you will return to the previous
screen settings.
When using either Resume Mode or the Stand by command, save
your files and make sure that no storage device is being accessed
before you turn off the computer. If you change your mind and
decide to continue working after all, wait a few seconds before
turning the computer on again.
The next time you turn on the power, you'll be able to continue
working from where you left off.
Hibernation mode
Hibernation is a Windows function. Unlike Resume or Stand by,
Hibernation saves your data to the hard drive.
Your Satellite computer is configured with Hibernation enabled. If
Hibernation is disabled and you want to enable it:
1 Open the Control Panel and double-click the Power icon.
2 Select the Hibernation tab.
Part I: Getting To Know Your Computer