Toshiba Satellite 4030CDT - Page 52

Getting Started
Connecting a mouse
2 Select Shut down, then click OK to shut down the computer.
Windows 98 shuts off the computer.
3 Attach the PS/2 mouse cable to the PS/2 port on the right side
of the computer.
HINT: You can only connect one PS/2 device at a time. Using
an optional Y-cable allows you to connect a PS/2 mouse and
a PS/2 keyboard to your computer simultaneously.
Refer your mouse documentation for configuration information.
Setting up a PS/2 mouse
Connecting a PS/2 mouse to your computer, allows you to use the
mouse, the AccuPoint, or both. To configure the PS/2 mouse to
work with the AccuPoint:
1 Click Start, Settings, then Control Panel.
Windows 98 displays the control panel screen.
2 Click the Hardware Setup icon.
3 Select the Hardware Options tab.
4 Select the Pointing Devices tab.
5 Under Pointing Devices Options, select one of the following:
♦ Auto-selected
Auto-selected configures the PS/2 mouse to work when it is
connected at power on, or the AccuPoint to work otherwise.
Auto-selected is the default option.
♦ Simultaneous
Simultaneous configures both the AccuPoint mouse and PS/2
mouse to work with the computer, at the same time. You must
reboot the computer for the settings to take effect.
Part I: Getting To Know Your Computer