2-7
Strata CTX I&M September 2002
Strata CTX100 Installation
5. Secure the top two screws approximately two thirds of the way into the top two holes on the back
board.
6. Hang the Base Cabinet back cover from the top two screws and then secure the top and bottom
screws completely into the back board. The base back cover should now be tightly secured to the
back board. See Figure 2-5.
7. To mount the Base Cabinet, position the cabinet hanger holes onto back cover hangers (two on top
and two on the bottom as shown in Figure 2-6). Slide the cabinet to the left.
8. Secure the Base Cabinet to the back cover with a screw through the left side bracket of the back
cover to the Base Cabinet. (See Screw “A” in Figure 2-5.)
9. If you are installing an Expansion Cabinet, go to “Step 5: Mount the Expansion Cabinet (if
required)” on Page 2-8. Follow the steps, then return to these steps.
Figure 2-5 Cabinet Wall Mounting
Screw A
Flange
Hook
Hook
Flange
Bas e
Exp an si o n
Stud
Plaster
Boa r d
Back Board
(1/2 Inch
Plywood)
5912
Bas e
Exp an si o n
To Next Page
Loading...
