2-9
Strata CTX I&M September 2002
Strata CTX100 Installation
8. To mount the Expansion Cabinet, position it onto the back cover hangers.
Note
Position the cabinet over the bottom right hanger first, and then carefully tilt the cover over the
top two hangers.
9. Slide the Expansion Cabinet to the left, feeding the data ribbon cable through the side hole of the
Expansion Cabinet.
10. Finish by securing the Expansion Cabinet to the Base cabinet with the two screws in front of the
cabinets where they join together. The expansion cabinet left-side flange fits over the Base cabinet
right side flange (see Figure 2-7).
11. On the AMAU motherboard of the Expansion Cabinet, flip open the two data ribbon locks, plug in
the data ribbon and close the locks. The data ribbon cable should now be connected to the Base
and Expansion cabinets.
12. Install PCBs into the Expansion Cabinet; follow the instructions in “Step 10: Install Other PCBs
into the Cabinet(s)”.
Note
The Base Cabinet DC power switch will be the master control for turning the DC power of
both cabinets On/Off.
13. Attach the outside covers on the Expansion Cabinet.
Figure 2-7 Base and Expansion Cabinet Interior
F lip open loc ks to plug in data c able. P ush
locks c losed onc e c able is plugged in. Make
sure loc ks are c losed.
L eft side of Expansion C abinet fits over
the right side of the Base C abinet.
2 - Screws
S101 S102 S103 S104 S105 S106 S107 S108
5969
To Next Page
Loading...
