Strata CIX Telephones Administrator Manual 06/06 1
Administrator Mode 1
This chapter contains some of the functions that can be performed using
Administrator Mode.
Important! These functions require Strata CIX release 4.1 or higher software.
You can access the Administrator mode using
DKT3000/3200/3500-series telephones.
Toshiba recommends using any 2-line display telephone.
To access the Admin mode, the telephone must
be enabled for this function in system
programming by the telephone system administrator.
Functions
Using the soft keys on your telephone, you can program the following functions in
Administrator mode:
• Phone Name – enter the Extension (PDN) name for any telephone in the Strata
CIX
•
Door Name – enter door phone name
• System SD/Name
1
– enables you to program system speed dial names
• Station SD/Name
1
– enables you to program station speed dial names for any
station in the system
• Exchange Line Name – program Exchange line names
• DNIS Name – program DNIS names
1 The Admin telephone mode allows speed dial names to be programmed but the actual speed dial numbers
are programmed using the speed dial programming procedures in this guide.
To Next Page
Loading...
Need help?
General