DKT/IPT Settings
Telephone Programming Mode
12 Strata CIX Telephones Administrator Manual 06/06
Call Waiting and Camp-on Ring Tone Over Handset/
Headset Option
Call Waiting and Camp-on tones are sent to a busy telephone’s speaker to indicate that
a call is waiting. Call Waiting and Camp-on Tones can be sent, as an option, to the
telephone handset or headset, in addition to the speaker. Follow these steps to turn
handset/headset Call Waiting and Camp-on tone On/Off for a DKT3000/3200/3500-
series telephone. The default is Off.
1. Press
3+6+9+Hold (simultaneously).
2. Press
0.
3. Press Feature Button 4 (FB4) to toggle On/Off.
FB4, LED On: Call Waiting tone
FB4, LED On: No Call Waiting tone
4. Press
Hold to set the option.
5. Go off-hook, then on-hook to exit the program mode.
Reset and Adjust the LCD Contrast
³ To adjust LCD Contrast for the LCD Telephones
1. Press
3+6+9+Hold (simultaneously).
2. Press and hold down the
Mic button, and press and release Vol ▲ or Vol ▼
repeatedly.
Each time you press
Vol ▲ or Vol ▼, the contrast increases or decreases. There are
eight steps in either direction. To return to the middle setting, repeat “Step 1”
above.
3. Press
Hold to reset the LCD contrast.
4. Go off-hook, then on-hook to exit the program mode.
³ To reset LCD Contrast for the DKT3014-SDL/3214-SDL
1. Press
3+6+9+Hold (simultaneously).
2. Press
SK1/Mode.
3. Press
Msg so that the Msg LED is On.
To Next Page
Loading...
Need help?
General