IPT2008-SDL Settings
Configurations
Strata CIX Telephones Administrator Manual 06/06 47
Reset
1. Select Configuration > Reset. The Reset screen
displays
...or if you press the SET soft key when a setting
change is made on the Network, Advanced and
Initialise subsidiary screens.
2. Press EXEC to reset the terminal. “Terminal is
reset. (Restart)” displays on the screen.
...or press CANCEL to go back to the
Configurations screen.
3. Select restart.
Note If the screen moves to the Configurations
screen without resetting, even though there are changes in subsidiary item
settings, then “Reset” will flicker (black and white) to prompt you to reset.
Reset does not flicker if there were no setting changes in subsidiary items.
Factory
³ Select Configuration > Factory. The Factory
Setting screen displays.
The general operation on the Key Repeat screens is
as follows:
• To view details of an item displayed on the
screens above, press the soft key that corresponds
to that item.
• Press the SET soft key to rewrite the NV-RAM
data if the ADM/DEBUG Mode is changed.
• Press the CANCEL soft key to cancel all the
intended setting changes under Factory items and to go to the Configurations
Screen without rewriting the NV-RAM data.
Reset execute ?
[EXEC] [CANCEL]
CONFIG
To Next Page
Loading...
Need help?
General