IPT2008-SDL Settings
Configurations
Strata CIX Telephones Administrator Manual 06/06 27
IP Address
³ Select Configuration > Network > IP Addr. The
IP Address screen displays (shown right).
The current IP Address displays.
³ To change settings on the screen
The following applies to the IP Address, Subnet
Mask, Default Gateway, and Primary DNS Server.
1. Use the dial pad (1~0, *) to enter a new IP
address.
Use
*
on the dial pad to enter a period (.) in an IP
address.
2. Press the SET soft key to select the setting change and go back to the Network
Setting Screen.
On the Network Setting Screen, the item you changed will be underlined in the
display (in this case the IP Address).
3. Pressing the SET soft key can give you an Error Screen if you incorrectly entered
the address.
4. Press the OK soft key on the Error Screen to correct the entry. Five seconds after
the Error Screen displays, the screen automatically goes back to the appropriate
setting screen (in this case the IP Address) and the address that resulted in an error
will be displayed.
5. Press the CANCEL soft key to cancel the setting change and to go to the Network
Setting screen.
IP Address
192.168.0.10 :Current
:New
Backspace = Vol-Down.
[SET] [CANCEL]
CONFIG
To Next Page
Loading...
Need help?
General