IPT2008-SDL Settings
Configurations
Strata CIX Telephones Administrator Manual 06/06 29
Station ID
³ Select Configuration > Network > Station.
The Station ID screen displays (shown right).
The current Station ID displays.
³ To Change or Add Information on this screen
1. Enter the New Station ID to change or add a
Station ID.
2. Press the SET soft key to accept the change
...or press the CANCEL soft key to cancel the
change and go to the Network Setting screen.
Notes
• Use the dial pad (1~0) to change or enter a new Station ID. Press Vol ▼ to
backspace.
• You can enter a maximum of seven digits.
• Pressing the SET soft key can give you an Error Screen if you incorrectly entered
the Station ID.
• Press the OK soft key on the Error Screen to correct the entry. Five seconds after
the Error Screen displays, the screen automatically goes back to the appropriate
setting screen (in this case the IP Address) and the address that resulted in an error
will be displayed.
Node Number
1. Select Configuration > Network Setting Screen
2 > Node. The current Node displays (shown
right).
2. Enter the Node. You must be first program this
node in eManager, Program 150, FB09.
3. Press the SET soft key to accept the change
...or press the CANCEL soft key to cancel the
change and go to the Network Setting screen.
Note Refer Station ID notes above.
Station ID
2000 :Current
:New
Backspace = Vol-Down.
[SET] [CANCEL]
CONFIG
To Next Page
Loading...
Need help?
General