IPT2008-SDL Settings
Configurations
36 Strata CIX Telephones Administrator Manual 06/06
External Administration User ID Setting
Use this screen to set an User ID. External accessing is enabled when the user can
successfully log in with correct User ID and Password
1. Select Configuration > Advanced Screen 2
> USER ID. The External Administration
User ID Setting screen displays (shown
right).
2. Enter the New User ID to change or add a
User ID.
3. Press the SET soft key to accept the change
...or press the CANCEL soft key to cancel
the change and go to the Network Setting
screen.
Note For other notes, refer to “Station ID” on page 29.
External Administration Password Setting
³ Select Configuration > Advanced Screen 2 >
PASSWORD. The Password screen displays
(shown right).
³ To change or add a new password
Note The Password can be alphanumeric, see
“Dial Pad Alphanumeric Characters” on
page 34 to enter the Password.
1. Press the Current soft key (left), then enter
the Current Password.
2. Press the New soft key (left), then enter the New Password.
3. To confirm the change, re-enter the new password in the New Again field using the
New Again soft key (left).
4. Press the SET soft key to accept the change
...or press the CANCEL soft key to cancel the change and go to the Network
Setting screen.
Note For other notes, refer to “Station ID” on page 29.
USER ID
9999 :Current
:New
Backspace = Vol-Down.
[SET] [CANCEL]
CONFIG
To Next Page
Loading...
Need help?
General