IPT2008-SDL Settings
Configurations
Strata CIX Telephones Administrator Manual 06/06 39
Headset Tx Volume Setting Screen
³ Select Configuration > Sound (screen 2) >
Headset Tx Vol. The Headset Tx Volume screen
displays.
³ To Change or Add Information on this screen
1. Enter the New field with the volume level.
2. Press the SET soft key to accept the change
...or press the CANCEL soft key to cancel the
change and go to the Sound Setting screen 2.
Notes
• Use the dial pad (1~0) to change or enter volume level. Press Vol ▼ to backspace.
• You can enter a maximum of seven digits.
• Pressing the SET soft key can give you an Error Screen if you incorrectly entered
the Station ID.
• Press the OK soft key on the Error Screen to correct the entry. Five seconds after
the Error Screen displays, the screen automatically goes back to the Headset Tx
Volume screen and the number that resulted in an error will be displayed.
Handset Rx Output Setting and Comfort Noise Setting
Important! The following steps apply to the above two items.
1. Select Configuration > Sound (screen 2) >
Handset Rx Mode or Comfort Noise. The
appropriate screen displays.
2. Press the ON or OFF soft keys to change the set
value.
3. Press the SET soft key to accept the change.
...or press the CANCEL soft key to cancel the
change.
The setting is underlined in the Sound screen
display.
Headset Tx Volume
3 :Current
:New (0:Min. -
7:Max.)
Backspace = Vol-Down.
[SET] [CANCEL]
CONFIG
To Next Page
Loading...
