4 Replacement Procedures 4.4 PC card/Bridge media/Smart card
4.4.2 Bridge media (SD Card/Memory Stick/xD Picture Card/MultiMedia card)
Removing the Bridge media
To remove the Bridge media, follow the steps below and refer to Figure 4-5.
CAUTION: Insert or remove a Bridge media in accordance with any instructions in each
Bridge Media manual or the manuals of the computer system you are using.
1. Push the Bridge media. It will pop out partly when you release, so pull out the card.
(For an instance, SD card is described in the figure 4-5.)
Bridge media
(SD card)
Figure 4-5 Removing the Bridge media
Installing the Bridge media
To install the Bridge media, follow the steps below and refer to Figure 4-5.
1. Insert the Bridge media and press it until it is securely connected.
4-16 [CONFIDENTIAL] TECRA A10/S10/P10/SatellitePro S300 Maintenance Manual (960-684)
To Next Page
Loading...
