Toshiba TECRA A10 - Page 313

4.28 Touch pad/Fingerprint sensor board 4 Replacement Procedures
3. Disconnect the touch pad FFC, touch pad button FFC and dual button FFC from
the connector CN9650 and CN3240 on the fingerprint sensor board and connector on
the touch pad.
NOTE: In models without a dual button, there is no dual button FFC.
4. Remove the unit dual pad (with the fingerprint sensor board).
CN3240
CN9650
Connector
Touch pad FFC
Dual button FFC
Touch pad
button FFC
Unit dual pad
(with the fingerprint sensor board)
Figure 4-51 Removing the touch pad/fingerprint sensor board (2)
TECRA A10/S10/P10/SatellitePro S300 Maintenance Manual (960-684) [CONFIDENTIAL] 4-81