Toshiba TECRA A10 - Page 314

4 Replacement Procedures 4.28 Touch pad/Fingerprint sensor board
5. Remove the following screws and separate the fingerprint sensor board and unit
dual pad.
• M2.0×3C S-THIN HEAD screw ×2
Unit dual pad
Fingerprint sensor board
M2.0x3C S-THIN HEAD
Figure 4-52 Removing the touch pad/fingerprint sensor board (3)
4-82 [CONFIDENTIAL] TECRA A10/S10/P10/SatellitePro S300 Maintenance Manual (960-684)