Toshiba TSL3000 - Abortion and Quitting Data Editing [NOSAVE]

OPERATOR’S MANUAL
series Robot Controller
5.2.6 Abortion and Quitting Data Editing [NOSAVE]
(1) Function
Aborts an edited data without saving it in a file and quits editing data.
(2) Procedures
(a) Step 1: Abortion of data editing.
Select the data display mode as shown below (i.e., the cursor is not present
on the command line), and press the NEXT key repeatedly until [NOSAV] is
displayed in the command menu.
P O I N T X Y Z
↑
P O I N T 0 0 0 0 3 = 1 0 0 , 1 0 0 , 1 0 0 ,
P O I N T 0 0 0 0 4 = 2 0 0 , 2 0 0 , 2 0 0 ,
P O I N T 0 0 0 0 5 = 300 , 300 , 3 00 ,
P O I N T 0 0 0 0 6 = 4 0 0 , 4 0 0 , 4 0 0 ,
↓
P O I N T 0 0 0 0 7 = 5 0 0 , 5 0 0 , 5 0 0 ,
P O I N T 0 0 0 0 5 w / . w o r l d
< N O S A V F I N D T E A C H M - T O C U T >
Press [NOSAV], and the system asks with a confirmation message if you wish
to abort the edited data.
P O I N T X Y Z
↑
P O I N T 0 0 0 0 3 = 1 0 0 , 1 0 0 , 1 0 0 ,
P O I N T 0 0 0 0 4 = 2 0 0 , 2 0 0 , 2 0 0 ,
P O I N T 0 0 0 0 5 = 300 , 300 , 3 00 ,
P O I N T 0 0 0 0 6 = 4 0 0 , 4 0 0 , 4 0 0 ,
↓
P O I N T 0 0 0 0 7 = 5 0 0 , 5 0 0 , 5 0 0 ,
[ N O S A V E ] O K T H E N < E X E > w / . w o r l d
< N O S A V F I N D T E A C H M - T O C U T >
STE 80720
– 5-18 –