Toshiba TSL3000 - Search of Coordinate Data [FIND]

OPERATOR’S MANUAL
series Robot Controller
5.4.7 Search of Coordinate Data [FIND]
(1) Function
Searches the data bearing the specified coordinate name.
(2) Procedures
Assume that you are going to search the coordinate data named
"TRANS00008."
(a) Step 1: Command selection.
Press the NEXT key repeatedly until [FIND] is displayed in the command
menu.
T R A N S S E L E C T I O N [ 3 / 1 1 ]
. w o r l d 1 0
w T R A N S 0 0 0 0 1 0
T R A N S 0 0 0 0 2 5
t T R A N S 0 0 0 0 3 0
↓
T R A N S 0 0 0 0 4 4
T R A N S 0 0 0 0 2
< N O S A V F I N D C U T P A S T E
Press [FIND], and the following display appears.
T R A N S S E L E C T I O N [ 3 / 1 1 ]
. w o r l d 1 0
w T R A N S 0 0 0 0 1 0
T R A N S 0 0 0 0 2 5
t T R A N S 0 0 0 0 3 0
↓
T R A N S 0 0 0 0 4 4
F I N D : _
(b) Step 2: Data name input.
Enter "TRANS00008", and the display is changed over as shown below.
T R A N S S E L E C T I O N [ 3 / 1 1 ]
. w o r l d 1 0
w T R A N S 0 0 0 0 1 0
T R A N S 0 0 0 0 2 5
t T R A N S 0 0 0 0 3 0
↓
T R A N S 0 0 0 0 4 4
F I N D : T R A N S 0 0 0 0 8 _
STE 80720
– 5-59 –