OPERATOR’S MANUAL
series Robot Controller
6.10 Variable Monitor
(1) Function
Displays the values of a desired global variable.
(2) Procedures
(a) Step 1: Command selection.
Press the NEXT key repeatedly until [WATCH] is displayed in the menu, and
press the corresponding function key.
• During stop
M O D E : T E A C H I N G / C O N T T E S T P R O
L : 28
O : 20%
M : F REE
S : S TOP
C O NT
M O D E O V R D R E S E T D O W A T C H >
• During run
M O D E : T E A C H I N G / C O N T T E S T P R O
L : 28
O : 20%
M : F REE
S : R UN
M O D E O V R D B R E A K S T O P W A T C H >
Press the [WATCH] function key, and the variable monitor display appears.
N A M E : _
C H G C H G + R
>
STE 80720
– 6-34 –
To Next Page
Loading...
