OPERATOR’S MANUAL
series Robot Controller
(b) Step 2: Input through EXE key.
Make sure that your entry is correct, and press the EXE key.
M O D E : I N T E R N A L
C O N T T E S T P R O
L : 28
O : 1 00%
M : F REE
S : S TOP
C ONT
S E L M O D E O V R D R E S E T >
(3) Caution
Use label RCYCLE in a desired step of the main program. Also, specify the
GOTO RCYCLE command just before the END command not to execute the
END command of the main program.
STE 80720
– 7-22 –
To Next Page
Loading...
