OPERATOR’S MANUAL
series Robot Controller
(c) Step 3: Designation of end position.
Move the cursor so that the final character of the specified range is indicated
by the reversed image. The specified range of blocks is inversely displayed
and you can delete the blocks under this condition.
P R G R A M . N A M C : 5 L : 1
P R O G R A M T E S T
S P E E D = 5 0
M O V E A
M O V E B
M O V E C
N O S A V C O P Y C U T P A S T E >
(d) Step 4: Deletion of specified range.
Press [CUT], and the contents of the specified range of blocks are saved in
the buffer with the specified range of blocks deleted.
The contents thus saved can be pasted at any desired position by pressing
[PASTE].
P R G R A M . N A M C : 5 L : 1
P R O G R A M T E S T
M O V E C
M O V E D
M O V E E
M O V E F
N O S A V C O P Y C U T P A S T E >
If the memory becomes full during setting, a warning saying "No more space
in cut buffer" is displayed.
P R G R A M . N A M C : 1 L : 4
M O V E A
M O V E B
M O V E C
M O V E D
M O V E E
N o m o r e i n c u t b u f f e r
N O S A V C O P Y C U T P A S T E >
(3) Caution
The deleted blocks are saved in the internal buffer.
STE 80720
– 4-21 –
To Next Page
Loading...
Need help?
General
