OPERATOR’S MANUAL
series Robot Controller
(d) Step 4: Check the file name to be edited.
Check that the file name is correct, and press the EXE key.
To change the file name, use the BS key to return the cursor, enter the new
file name using the keyboard, and then press the EXE key.
(e) Step 5: Creation of batch file.
Enter a command that is enabled in batch processing and a file name that
executes the command line by line.
A U T O S T R . B A T C : 1 L : 1
S E L E C T A R C M O V 1 0
O V R D 5 0
S A V E D E D I T J U M P F I N D C H A N G >
(f) Step 6: Quit the editor.
Press [SAVE] to quit the editor.
This completes the creation of the batch file for batch processing.
(3) Execution of batch file
If the AUTOSTR. BAT file is stored in the RAM drive when the power is turned
on, the batch file is automatically executed after the startup process.
(4) Cautions
• The following commands are enabled in batch processing
SELECT <file name> : Selecting file
OVRD <override setting value> : Override setting
DATE : Date display
TIME : Time display
SVON : Servo ON command
RUN : Program run command
• The SVON command is enabled in internal automatic (INTERNAL) mode
and external automatic (EXT) mode.
STE 80720
– 4-35 –
To Next Page
Loading...
