OPERATOR’S MANUAL
series Robot Controller
• For the X, Y, Z, C, and T data, a value of four (4) digits and three (3) digits above
and below the decimal point, respectively, can be input. In this mode, however,
only a value of four (4) digits above the decimal point is displayed. For the data
indicted by the main cursor, a full value is displayed, including decimal fractions.
When you display values included in C data and subsequent data, move the main
cursor to the right. The following display appears.
Z C T CONF I G
1 0 0 , 1 0 0 ,0/FREE
2 0 0 , 0 , 0 / F R E E
3 0 0 , 0 ,0/RIGH T Y
4 0 0 , 0 , 0 / L E F T Y
5 0 0 , 0 , 0 / F R E E
1 0 0 . 0 0 0 w / . w o r l d
S A V E P R G F U L L T R A N S P Y L D >
STE 80720
– 5-4 –
To Next Page
Loading...
