Toshiba VF-PS1 - Page 267

K-25
E6581386
11
[26] Communication function [2/4] Sensorless vector/vector with sensor (●:Effective, -:Ineffective)
Title
Communi
cation
No.
Function Adjustment range
Minimum
setting unit
(Panel/Communi
cation)
Default
setting
Write during
running
Vector
control
PM
control
V/f Constant
Reference
 0826
Inverter-to-inverter communication setting (4-wire RS485)
0:Slave (issues a 0Hz command if something goes
wrong with the master)
1:Slave (continues operation if something goes
wrong with the master)
2:Slave (trips for emergency stop if something
goes wrong with the master)
3:Master (sends a frequency command) 4:Master (sends an output frequency) 5: - 6: -
1/1 0 Enabled ●/●●●6. 34. 1
 0829 Protocol selection (4-wire RS485)
0:TOSHIBA 1:MODBUS
1/1 0 Enabled ●/●●●6. 34. 1
 0830
Communication option (DeviceNet/ PROFIBUS) setting 1
0~7 1/1 0 Enabled ●/●●● *1
 0831
Communication option (DeviceNet/ PROFIBUS) setting 2
0000~ 1/1 0000 Enabled ●/●●● *1
 0832
Communication option (DeviceNet/ PROFIBUS) setting 3
0000~ 1/1 0000 Enabled ●/●●● *1
 0833
Communication option (DeviceNet/ PROFIBUS) setting 4
0000~ 1/1 0000 Enabled ●/●●● *1
 0834
Communication option (DeviceNet/ PROFIBUS) setting 5
0000~ 1/1 0000 Enabled ●/●●● *1
 0835
Communication option (DeviceNet/ PROFIBUS) setting 6
0000~ 1/1 0000 Enabled ●/●●● *1
 0836
Communication option (DeviceNet/ PROFIBUS) setting 7
0000~ 1/1 0000 Enabled ●/●●● *1
 0841
Communication option (DeviceNet/ PROFIBUS) setting 8
0000~ 1/1 0000 Enabled ●/●●● *1
 0842
Communication option (DeviceNet/ PROFIBUS) setting 9
0000~ 1/1 0000 Enabled ●/●●● *1
 0843
Communication option (DeviceNet/ PROFIBUS) setting 10
0000~ 1/1 0000 Enabled ●/●●● *1
 0844
Communication option (DeviceNet/ PROFIBUS) setting 11
0000~ 1/1 0000 Enabled ●/●●● *1
*1: ⇒ For details, refer to Instruction Manual (E6581281, E6581343) specified in Section 6.36.