Archer C3200 AC3200 Wireless Tri-Band Gigabit Router
2) In the CLI window, type in “ping 192.168.2.x” (“192.168.2.x” can be IP
address of any host in Site B). Then press [Enter].
If Ping proceeds successfully (gets replies from host in Site B), the IPSec
connection must be working properly now.
Note:
1) The product supports a maximum of ten simultaneous connections.
2) If one of the site has been off line for a while, for example, if Site A has
been disconnected, on Site B you need to click Disable and then click
Enable after Site A back on line in order to re-establish the IPSec
tunnel.
Completed!
The VPN tunnel is established.
- 84 -
To Next Page
Loading...
