What to do if my TPS smartCHEM-Titro displays a constant reading around pH7.00 or 0mV?
If your TPS Laboratory Equipment displays a constant reading around pH7.00 or 0mV for all solutions, it indicates an electrical short in the connector. Check the connector and replace it if necessary. If the issue persists, replace the electrode.
What to do if my TPS smartCHEM-Titro gives inaccurate readings after successful calibration?
Inaccurate readings in your TPS Laboratory Equipment, even after successful calibration, are likely due to a blocked reference junction. Clean the reference junction as per the instructions supplied with the electrode.
Why does 2 or 3 point pH calibration fail on my TPS smartCHEM-Titro?
A 2 or 3 point pH calibration may fail on your TPS Laboratory Equipment if: * pH buffers are not correctly set; for automatic pH buffer recognition, ensure that you are using buffers that match the selected buffer set. Otherwise, ensure that the buffer value is entered correctly at pH calibration. * The pH glass bulb is not clean; clean it as per instructions supplied with the electrode. * The electrode is aged; attempt rejuvenation as per instructions supplied with the electrode. If unsuccessful, replace the electrode. * The connector is damp; dry in a warm place. * pH buffers are inaccurate; replace standards or buffers.
What to do if my TPS Laboratory Equipment reading does not change?
If the reading on your TPS Laboratory Equipment does not change in any sample being measured, the Auto Stability Function may have frozen the display. Turn the Auto Stability Function OFF or restart sampling.
What to do if my TPS smartCHEM-Titro displays 4-5 pH for all solutions?
If your TPS Laboratory Equipment displays 4-5 pH for all solutions, it means that the pH electrode glass bulb or internal stem is cracked. Replace the pH electrode.
What to do if my TPS smartCHEM-Titro fails to calibrate, even with a new probe?
If your TPS Laboratory Equipment fails to calibrate, even with a new probe, it is because calibration settings are outside of allowable limits due to a previous failed calibration. Initialise the unit.
What does it mean when my TPS smartCHEM-Titro says 'Waiting for Burette Press Menu to exit'?
This message on your smartCHEM-Titro TPS Laboratory Equipment means that it could not detect the Schott Burette because: 1. The burette is not connected. 2. The burette is not switched on. Connect the burette and switch it on. The On/Off switch is located on the rear of the unit.
How to fix a failed 1 point calibration on my TPS Laboratory Equipment?
A 1 Point calibration failure on your TPS Laboratory Equipment (pH asymmetry is greater than ±1.00 pH, or mV offset is greater than ±60mV) can be fixed by cleaning the reference junction as per instructions supplied with the pH or reference electrode. Flush with distilled water and replace the electrolyte.
What does it mean when my TPS smartCHEM-Titro Laboratory Equipment says 'Burette Not Detected Cannot Titrate'?
This message appears when communication with the burette is lost some time after the meter was turned on. To solve this, connect the burette and switch it on. The On/Off switch is located on the rear of the unit.
What to do if the temperature reading on my TPS smartCHEM-Titro Laboratory Equipment is inaccurate?
If the temperature reading on your TPS Laboratory Equipment is inaccurate and cannot be calibrated, check the connector and replace if necessary. If the problem persists, return the Temperature sensor for repair, or replace the sensor.
General| Brand | TPS |
|---|---|
| Model | smartCHEM-Titro |
| Category | Laboratory Equipment |
| Language | English |
To Next Page
