TPS smartCHEM-Titro - 3 Automatic Titrator Mode; Selecting Automatic Titrator Mode

11
3. Automatic Titrator Mode
3.1 Selecting Automatic Titrator Mode
1. Select the Mode menu ( →
→→
→ F3:Mode)…
Mode
>F1:0.01pH F2:0.001pH
F3:mV F4:Rel mV
>F5:Titrator
The arrow indicates the current selection.
2. Select F5:Titrator from the menu. The Titrator mode section menu is now displayed…
TITRATOR
>F1:Titrator ON
F5:Titrator OFF
The arrow indicates the current selection.
Press to turn the Automatic Titrator function ON.
Press to turn the Automatic Titrator function OFF.
Press to quit without changing the current selection.
3. In normal display mode, the smartCHEM-Titro will now prompt you to press to start the
Standard Titration. For example…
7.00pH 25.0
o
C
0.00mL 12:00:00
Press F6 to start
STD Titration
If the Automatic Datalogging function is programmed (as per section 12.2), an additional
prompt informs the user that the titration curve will be logged into memory. For example…
7.00pH 25.0
o
C
0.00mL 12:00:00
Press F6 to start
STD Titration & Log
See section 3.3 for details on setting up the Standard Titration parameters to your specific
requirements.