5. The smartCHEM-Titro will ask if the records are to be logged into the instrument’s
memory, or sent directly to the RS232 port. The display will look like this…
F1:Log to Memory
F2:Send to RS232
Press to log records into the Logger (maximum of 2340 readings).
Press to send records directly to the RS232 port.
6. The automatic logging function is now programmed, and can be started and stopped as
required.
7. To start automatic logging, press in normal display mode.
When any period greater than Zero is programmed, Datalogging starts and stops
automatically during a titration procedure.
When the smartCHEM-Titro is logging into its own memory, the display will look like this…
7.00pH 25.0
O
C
31/12/04
Log#1 12:00:00
The log number will increment and the smartCHEM-Titro will beep each time a reading is
recorded.
If the smartCHEM-Titro is sending records directly to the RS232 port, the display will look
like this…
7.00pH 25.0
O
C
31/12/04
The smartCHEM-Titro will beep each time a record is sent to the RS232 port.
8. Press to stop automatic logging.
Hint : Press before starting automatic logging to make the smartCHEM-Titro stop logging as
soon as all the readings have become stable. See section 8 for more details on the Auto
Stability Function.
To Next Page
Loading...
