Tracker Off-Road 500S - Page 80

78
FI641A
3. Remove the driveshaft (C); then pull the shift fork
locating shaft (D) out of the crankcase locating boss
and allow the shift forks to disengage from the gear
shift shaft (F).
FI646
FI653A
4. Remove the gear shift shaft (F) noting the inner and
outer washers.
FI650A
5. Remove the countershaft assembly (E) along with
the shift fork assembly.
FI662
6. Remove the crank balancer driven gear (G) and
account for a key; then remove the crankshaft bal-
ancer shaft.
MD1024
7. Using Crankcase Separator/Crankshaft Remover
with the appropriate crankshaft protector, remove the
crankshaft.
MD1330
CAUTION
Do not remove the remaining output shaft assembly
unless absolutely necessary. If the shaft is removed, the
shaft nut must be replaced with a new one and the shaft
must be re-shimmed.