Trail Tech STRIKER - Configuring Voltage Alerts

36
36
Setup Mode
Setup Low Voltage LED:
MODIFY DIGIT: LEFT BUTTON
NEXT DIGIT: RIGHT BUTTON
TO CONFIRM, PRESS THE CENTER BUTTON.
Striker will move on to the next setting.
MODIFY DIGIT: LEFT BUTTON
NEXT DIGIT: RIGHT BUTTON
TO CONFIRM, PRESS THE CENTER BUTTON.
Striker will move on to the next setting.
If voltage falls below this
setting, the red LED will flash
as a critical warning.
0V (default) disables this alert.
If voltage falls below this
setting, the yellow LED will
flash on as a caution.
0V (default) disables this alert.
Setup Danger Voltage LED: