41
FAQ Troubleshooting
The screen is hazy or crazed.
•
The backlight won’t stay lit.
•
Striker’s internal battery is dead.
•
Why aren’t the LEDs working?
•
•
•
The maintenance icons won’t clear off the screen.
•
Did gasoline, degreasers, or other chemical cleaners come in
contact with Striker’s screen? Chemicals can damage Striker.
Striker needs to be connected to vehicle’s 12 volt system in
order for the backlight to be continuous on. Review installation
procedure. See page 9 and 29.
To replace the battery, use a coin to unscrew the round panel
on the back of Striker. Remove the old battery and install the
new one. Make sure the positive pole is facing up. Replace
with common watch battery CR2302. See page 10.
Striker needs to be connected to the vehicle battery in
order for the LEDs to function.
Settings must be programmed manually. See pages 35-36.
The LEDs dim or go out if the vehicle battery voltage is too low.
Go into setup mode and make sure OIL and CARE are both
set to 0. The icons should then disappear from the normal
screens. See page 37.
To Next Page
Loading...
Need help?
General