BAS-SVU044D-EN
29
1. On the thermostat Home screen, tap MMeennuu >> SSeettttiinnggss >> SSccrreeeennss >>
LLaanngguuaaggee.
2. Select a language. The thermostat will run through the initialization
process, after which the new language will be displayed.
Emergency Heat Enable
Emergency Heat can be enabled at the thermostat or from the Trane Pivot
mobile app.
NNoottee:: Emergency heat is only available if your system is a heat pump.
AAtt tthhee tthheerrmmoossttaatt:
1. On the thermostat Home screen, tap SSyysstteemm MMooddee >> SSyysstteemm OOppttiioonnss >>
EEmmeerrggeennccyy HHeeaatt EEnnaabbllee >> DDoonnee.
AAtt tthhee PPiivvoott mmoobbiillee aapppp:
1. From the Dashboard screen, navigate to the building where the
thermostat is installed.
2. Tap SSeettttiinnggss in the lower right corner, then tap the EEmmeerrggeennccyy HHeeaatt
selection to enable (or disable).
Open Automatic Demand Response (OADR)
The Open Automatic Demand Response (OADR) program option works in
conjunction with local utility or energy aggregators to reduce energy
consumption during peak demand periods. When enrolled in this program
the utility or energy aggregator transmits a signal to the thermostat, which
automatically sets the cooling setpoints higher or the heating setpoints
lower. Typically these events last for a few hours and have little impact on
occupant comfort.
To register the thermostat for OADR:
From the Home screen on the thermostat, tap MMeennuu > SSyysstteemm IInnffoo >
DDeemmaanndd RReessppoonnssee > RReeggiissttrraattiioonn.
The UURRLL and PPoorrtt NNuummbbeerr is obtained from the utility or aggregator web
site. The VVEENN IIDD is an identity you create for your thermostat.
NNoottee:: It is strongly recommended to have PIN Access restriction set up on
the thermostat if using the OADR feature.
CCuussttoommiizzaattiioonn aanndd AAddddeedd FFeeaattuurreess
To Next Page
Loading...
Need help?
General
