EasyManua.ls Logo

Trane TCONT900AC43UA - Page 259

Trane TCONT900AC43UA
336 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
AC - A 25
Electronic Air Cleaners
Step 5
Replace the door onto the Air Cleaner cabinet.
Step 6
Ensure that the power cord is connected to the Air
Cleaner and press the Power button.
Note: Once you press the Power button, the first LED
will be on and it will start flashing after the first 10 [12]
minutes of indoor fan operation. This is normal opera-
tion.
Step 7
On the thermostat, reset the indoor fan operation to
the desired mode. Turn the air system back on at
the Comfort Control (thermostat).
Note: The field charger should never be subjected to
water. The field charger should only be cleaned by a
trained service professional.
Note: The Pre-Filter may also be washed only if the
Collection Cells show a "200/200-1". Follow the same
instructions to wash the PRE-FILTER - being sure to
tap gently and wipe off any visible water droplets.
Reset Timers
To reset the Pre-Filter timer, press and hold the Reset
button until the Pre-Filter LED turns off. (1 to 2 sec-
onds). To reset the Collection Cell timer, press and
hold the Reset button until the Collection Cell LED’s
turn off. (4 to 5 seconds).
In a communicating system, the filter reset timers
can also be reset at the communicating comfort con-
trol. If two air cleaners are connected on the same
system, reset all timers on both air cleaners at the
same time to the same settings. The comfort control
will only report one air cleaner timer and this method-
ology will allow the air cleaners to remain on the same
cleaning schedule.
Cleaning The Field Charger
Step1
Turn off the Air Cleaner and remove the Power Door.
Step 2
Bend the Field Charger metal locking tabs down
against the case.
Step 3
Remove the Field Charger from the case. Lay the Field
Charger on a secured flat surface.
CAUTION
Risk of Injury. Field charger pins are sharp. Do not
bend field charger pins. Wear appropriate gloves when
handling the field charger. Failure to handle field charger
pins properly may result in minor to moderate injury.
Step 4
Wipe down the faceplate of the Field Charger with a
dry shop towel or use a vacuum cleaner. Do not dis-

Table of Contents

Other manuals for Trane TCONT900AC43UA

Related product manuals