RT-PRC024-EN 83
Table 77. Typical Number of Wires
Zone Sensors
A Manual Changeover.............................. 4
Manual/Auto Changeover...................... 5
Manual/Auto Changeover with
Status Indication LED’s......................... 10
Programmable Night Setback
with Status Indication LED’s................... 7
Thermostats
B 3 Power Wires + 1 Ground Wire (three phase)
2 Power Wires + 1 Ground Wire (single phase)
For specific wiring information, see the installation instructions.
All wiring except power wire is low voltage.
All customer supplied wiring to be copper and must conform to applicable electrical codes
(such as NEC or CEC) and local electric codes. Wiring shown dotted is to be furnished and
installed by the customer.
DISCONNECT
SWITCH
(BY OTHERS)
ZONE SENSOR OR
THERMOSTAT
ROOFTOP
UNIT
A
B
Jobsite Connections
To Next Page
Loading...
