Transcell Technology TI-1680 - Zero Calibration (F16); Span Calibration (F17)

21
8. Once the setting you want is displayed on the screen, press the MODE (set) key to save this
value and revert up to the parameter level, e.g.,” B1”.
Batching (“B”) Menu Descriptions
This section provides more detailed descriptions of the selections found in the Batching Menu
Chart. Factory-set defaults are shown in bold with a checkmark; (√).
CODE/NAME
DESCRIPTION
SELECTION LIST
B1
Input Function
Assigns a keypad function to the input terminal: J4:3.
"0" = Print, "1" = Zero, “2” = Tare, “3” = Units, “4” = F1
0 
1, 2, 3, 4
B2
Input Logic
Assigns the “active” logic level to the input terminal: J4:3.
"0" = Low logic, "1" =High logic
0 
1
B3
Batch Mode
Selects the specific Batch Mode. F30 must be set to “7”.
“0” = Manual, “1” = Automatic, “2” = Filling, “3” = Continuous
0 
1, 2, 3
B4
Output Logic
Assigns the “active” logic level to each of the four output terminals.
This menu selection has four sub-menus: “B4U1” (OUT1), B4U2”
(OUT2), B4U3” (OUT3), and B4U4” (OUT4), all with identical selec-
tions.
"0" = Low logic, "1" =High logic
0
1 
B5
Front Panel
Access Pass-
word
Assign the password to allow front panel access. Front panel access
may be password protected. See A17.
Key-in
0 - 999999
336699 
B6
Cutoff Delay
Assign a cutoff delay (in seconds) to each of the four output termi-
nals. This is used for in-flight compensation. This menu selection has
four sub-menus: “B6U1” (OUT1), B6U2” (OUT2), B6U3” (OUT3), and
B64U4” (OUT4), all with identical selections.
Key-in
0.0 – 10.0
0 