55
Upgrading Firmware
Each time the Wi-Fi SD App is launched while connected to the Wi-Fi SD Card; it will
check your card’s firmware version. If a newer version is available, a popup message
will notify you. Please go to
www.transcend-info.com/downloads
to download it.
For Windows/Mac user, please download Wi-Fi SD Firmware Update Tool
(Windows/Mac ver.) to upgrade firmware.
Note: To prevent data loss, it is recommended that you backup your data to
another location before upgrading the firmware of your Wi-Fi SD card.
1. Download the firmware files and insert the Wi-Fi SD card into your computer.
(depending on your computer setup, you may need to use an SD card reader)
2. Copy the firmware files to the root directory of Wi-Fi SD card.
3. Eject the drive and remove the Wi-Fi SD card from your computer.
4. Re-insert the Wi-Fi SD card into your camera.
5. Power on the camera and wait for 5 minutes.
6. After 5 minutes, turn camera power off and on again to complete upgrade.
IMPORTANT: Please disable power saving and do NOT power off your
camera during firmware upgrade. Any interruption during the process
may cause unexpected results.
To Next Page
Loading...
