9
Connecting to the Wi-Fi SD Card using iOS and
Android Devices
To wirelessly access Wi-Fi SD card digital content on your iOS/Android device, you
must first connect to the Wi-Fi SD card’s dedicated wireless network.
Direct Share
(Peer-to-peer connection with iOS/Android device(s))
Direct Share mode allows you to browse photos and videos stored on the Wi-Fi SD
card on your iPhone/iPad/Android device. When connected to the Wi-Fi SD card in
Direct Share mode, your device will not have Internet access.
(On your camera)
1. Insert the Wi-Fi SD card and power-on the camera. (For directions on inserting
an SD card into your camera, please see your camera’s user manual.)
By default, the Wi-Fi SD card’s wireless network signal will automatically broadcast in
Direct Share mode once the camera is powered on. (To change the preferred default
startup mode, please see the Settings section for detailed instructions.)
(On your iOS device)
2. Tap Settings, then Wi-Fi.
3. Under Choose a Network… select WIFISD. (After turning on the camera, please
wait around 25 seconds for the network to appear. Default Wi-Fi security key:
‘12345678’. To change the default SSID and setup a Wi-Fi security key, please
see the Settings section for detailed instructions.)
(On your Android device)
2. Tap System Settings, then Wi-Fi.
3.
Under Wi-Fi, select WIFISD. (After turning on the camera, please wait around 25
seconds for the network to appear. Default Wi-Fi security key: ‘12345678’. To
change the default SSID and setup Wi-Fi security key, please see the Settings
section for detailed instructions.)
To Next Page
Loading...
