TransCore MPRX Series - Appendix D Command Quick Reference; Command Syntax; Factory Default Settings

AppendixDCommand Quick Reference
Command Syntax
The command numbers consist of from 2 to 4 hex digits. The letters N or S may follow a command
number. The letter N indicates that part of the command number is variable. The letter S indicates the
requirement for an alphanumeric data string that is to be included immediately following the command
number. Hex digits (0–9, A–F) in either uppercase or lowercase characters may be used in data strings
and for hex digits A–F. For more information refer to “Chapter 3 General Software Information” on page
3–38.
Table 36 lists factory default settings. Table 37 lists, in numerical order, all of the commands available to
users. Table 38 lists the same commands by command name.
Factory Default Settings
Table 36 lists the factory default settings for the MPRX.
Table 36 MPRX Default Configuration Settings
Parameter Setting
Command
Operating mode Data
00
Baud rate 9600
1005
Stop bits 1
1010
Parity None
1020
Time and data appended Enabled
302
Auxiliary information appended Disabled
310
Unique ID code criteria Separation of 1 ID
4100
Valid ID code criteria Acquisition of 1 ID
4200
Uniqueness time-out 2 minutes
441
Tag translation mode Disabled
452
Multi-tag sort Disabled
454
SeGo protocol tag initialization
during multi-tag sort
Enabled
456
Reader ID number 00
6000
MPRX User Guide
TransCore Proprietary
D–116