Table 36 MPRX Default Configuration Settings
Parameter Setting
Command
Communications protocol Basic
610
Error correcting protocol (ECP)
timeout
12.7 sec
612FE
Flow control Software (XON/XOFF)
6141
Echo mode Enabled
6171
RF-by-input control Enabled
641
ATA operating range (distance) Maximum
6431F
RF attenuation Full power
64400
SeGo protocol operating range
(distance)
Maximum
6451F
Presence without tag reports Disabled
6900
RF-o control Timeout or no presence
6922
RF timeout Never true
693F
Input inversion Disabled
6940
Serial number SSSSSS
695
Store hardware configuration
Hardware configuration not
known
696
Automatic periodic RF status
report
Disabled
830
Numerical Command List
The following conventions are used in Table 37.
Items in bold identify factory default settings.
Only the command-related data portion of the reader message is shown.
Refer to “Chapter 5 Commands” on page 5–56 for the complete syntax of commands and messages.
Appendix D Command Quick Reference
TransCore Proprietary
D–117
To Next Page
Loading...
