Table 26 MPRX Default Configuration Settings
Parameter Setting Command
Software flow control Software (XON/XOFF)
6141
Echo mode Enabled
6171
ATA operating range Maximum
6431F
RF attenuation Full power
64400
SeGo protocol tag operating range Maximum
6451F
Presence without tag reports Disabled
6900
RF-o control Timeout or no presence
6922
RF timeout Never true
693F
Input inversion Disabled
6940
Serial number SSSSSS
695
Store hardware configuration
Hardware configuration
not known
696
Automatic periodic RF status report Disabled
830
Terminal Emulation Software
To configure the MPRX using a PC and terminal emulation software to manually enter MPRX host
commands, follow the instructions in the section “Connecting the MPRX to the Host Port” on page 2–32
Then, enter the appropriate configuration commands through the terminal emulation software on the host.
Refer to “Commands” on page 5–56 for a detailed description of all available configuration commands.
Chapter 6 Configuration
TransCore Proprietary
6–87
To Next Page
Loading...
