TransCore MPRX Series - Table 15 Append Time and Date Commands; Table 16 Append Auxiliary Information Commands

reported. If this is unacceptable, allow the buer to empty before reissuing append time
and date Command #30N Append Time and Date commands are shown in Table 15.
Table 15 Append Time and Date Commands
Command Append Option
300
No time and date appended
302
Time and date appended (factory default)
The reader transmits messages with time and date appended as follows. One space separates the time
from the date.
<string>&<HH:MM:SS.hh MM/DD/YY>
where
string is a tag ID, error message, or report.
& separates <string> from the time and date.
HH:MM:SS is the time delimiter.
MM/DD/YY is the date delimiter.
Reader response: #Done
31N Append Auxiliary Information Selection
#31N selects the option of appending auxiliary information to transmitted IDs, presence-
without-tag reports, and input status change reports. Auxiliary information is not
appended to error messages. The factory-default setting is no auxiliary information
appended. The N variable specifies whether or not auxiliary information is to be
appended. Append Auxiliary Information commands are shown in Table 16.
Table 16 Append Auxiliary Information Commands
Command Append Option
310
No auxiliary information appended (factory default)
311
Auxiliary information appended
The reader transmits messages with auxiliary information appended as:
<message data>%<xx-y-zz-q-sss>
where
% separates the auxiliary information and signals the host computer that auxiliary
information is appended.
xx reader ID. Value can be set with Command #60NN.
- auxiliary information delimiter
y antenna number.
zz number of reads (00 to FF hexadecimal) of the previous tag on this antenna
MPRX User Guide
TransCore Proprietary
5–62