TransCore MPRX Series - Table 37 MPRX Commands Listed Numerically

To Next Page

To Previous Page

Table 37 MPRX Commands Listed Numerically

Number Command Name Reader Message

00 Switch to data mode (default)

#Done

01 Switch to command mode

#Done

1002 Set baud rate = 1200 baud

#Done

1003 Set baud rate = 2400 baud

#Done

1004 Set baud rate = 4800 baud

#Done

1005 Set baud rate = 9600 baud (default)

#Done

1006 Set baud rate = 19.2 K baud

#Done

1007 Set baud rate = 38.4 K baud

#Done

1010 Use one stop bit (default)

#Done

1011 Use two stop bits

#Done

1020 Disable parity (default)

#Done

1021 Select even parity

#Done

1022 Select odd parity

#Done

20 Set time

#Done

21 Set date

#Done

22 Display time and date

HH:MM:SS.hh MM/DD/

300 No time and date appended

#Done

302 Time and date appended (default)

#Done

310 Disable aux info append (default)

#Done

311 Enable aux info append

#Done

40 Transmit all IDs

#Done

4100 Select one ID separation (default)

#Done

4101 Select two ID separation

#Done

4102 Select three ID separation

#Done

4103 Select four ID separation

#Done

MPRX User Guide

TransCore Proprietary

D–118

Main Page

TransCore MPRX Series - Table 37 MPRX Commands Listed Numerically

Table of Contents

Related product manuals