TransCore MPRX Series - Alphabetical Command List; Table 38 MPRX Commands Listed Alphabetically

Table 37 MPRX Commands Listed Numerically
Number Command Name Reader Message
831 Enable automatic periodic RF status report
#Done
836 Disable MPRX mode
#Done
837 Enable MPRX mode
#Done
850 MUX RF port 0 (default)
#Done
851 MUX between RF ports 0 and 1
#Done
852 MUX between RF ports 0, 1, and 2
#Done
853 MUX between RF ports 0, 1, 2, and 3
#Done
891 MUX test mode RF port 1 only
#Done
892 MUX test mode RF port 2 only
#Done
893 MUX test mode RF port 3 only
#Done
Alphabetical Command List
The following conventions are used in Table 38:
Items in bold identify factory default settings.
Only the command-related data portion of the reader message is shown.
Refer to “Chapter 5 Commands” on page 5–56 for the complete syntax of commands and messages.
Table 38 MPRX Commands Listed Alphabetically
Command Name Number Reader Message
ATA Operating Distance =
Maximum (default)
6431F
#Done
Disable ATA 480
#Done if MPRX model supports
this tag protocol, #Error if tag
protocol is unsupported
Disable automatic periodic RF
status report (default)
830
#Done
Disable aux info append (default) 310
#Done
MPRX User Guide
TransCore Proprietary
D–124