Table 38 MPRX Commands Listed Alphabetically
Command Name Number Reader Message
Disable eATA 488
#Done if MPRX model supports
this tag protocol, #Error if tag
protocol is unsupported
Disable echo mode 6170
#Done
Disable flow control 6140
#Done
Disable input inversion (default) 6940
#Done
Disable MPRX mode 836
#Done
Disable multi-tag sort (default) 454
#Done
Disable parity (default) 1020
#Done
Disable presence without tag
reports (default)
6900
#Done
Disable SeGo 484
#Done if MPRX model supports
this tag protocol, #Error if tag
protocol is unsupported
Disable SeGo protocol tag
initialization during multi-tag sort
457
#Done
Disable tag translation mode
(default)
452
#Done
Display appended info status 524
IDAP T<0 to 1> D<0 to 1>
X<0 to 1>
Display boot checksum 543
BCKS xxxx
Display comm port parameters 522
MAIN B<2 to 7> S<0 to 1>
P<0 to 2> D0
Display comm protocol 525
ECPS P<0 to 2> T<01 to
FF> X<0 to 2> S0
Display echo status 537
ECHO <0 to 1>
Display flash checksum 540
PCKS I0000 Exxxx
Display hardware configuration
information
506
S...S (Max 20 characters)
Display input status change 560
SSTC E<0 to 1> M<0 to 3>
Display operating mode status 570
ATA:<E, D> eGo:<I, F, D>
SeGo:<I, F, D> IAG:<E, D>
Sort:<E, D> TMM0
Display power fail bit 520
PWRB P<0 to 1> R0
Appendix D Command Quick Reference
TransCore Proprietary
D–125
To Next Page
Loading...
