Appendix D Command Quick Reference
TransCore Proprietary
D–119
Table 37 MPRX Commands Listed Numerically
Number Command Name Reader Message
4200 Select 1 valid ID code (default)
#Done
4201 Select 2 valid ID codes
#Done
4202 Select 3 valid ID codes
#Done
4203 Select 4 valid ID codes
#Done
440 Reset uniqueness
#Done
441
Set uniqueness time-out to 2 minutes
(default)
#Done
442 Set uniqueness time-out to 15 seconds
#Done
443 Set uniqueness time-out to 30 seconds
#Done
452 Disable tag translation mode (default)
#Done
453 Enable tag translation mode
#Done
454 Disable multi-tag sort (default)
#Done
455 Enable multi-tag sort
#Done
456
Enable SeGo protocol tag initialization
during multi-tag sort (default)
#Done
457
Disable SeGo protocol tag initialization during
multi-tag sort
#Done
480 Disable ATA
#Done if MPRX model
supports this tag protocol
#Error if tag protocol is
unsupported
481 Enable ATA
#Done if MPRX model
supports this tag protocol
#Error if tag protocol is
unsupported..
484 Disable SeGo
#Done if MPRX model
supports this tag protocol
#Error if tag protocol is
unsupported
485 Enable SeGo
#Done if MPRX model
supports this tag protocol
#Error if tag protocol is
unsupported
To Next Page
Loading...
