transnorm TS 1300 - Page 53

Maintenance and care
Maintenance schedule
53
Operation-related maintenance schedule
Interval Assembly Maintenance/inspection
Weekly Complete machine Visual inspection:
 After work or in the case of a shift change-
over, make sure all possible load residues
are cleared out of the machine.
 Foreign particles/foreign objects are not
permitted on the conveyor belt or in the
pulley/roller areas.
Weekly Protective devices Visual inspection:
 Is the equipment complete according to
the specifications in the operating instruc-
tions?
 Is all the equipment undamaged and func-
tional?
Weekly Conveyor belt Visual inspection:
 Is the belt soiled? If so, clean belt.
 Is the surface damaged? If so, replace belt.
 Is the belt bulging up? If so, correct belt
tension and adjustment.
Depending
on the indi-
vidual case
Gear motor
Observe the oper-
ating instructions
provided by the
manufacturer!
Gear:
 Are there any oil marks under the gear? If
so, seal off leak and correct oil level.
 Check mounting and alignment.
 Can abnormal running noise be heard?
Check bearings.
Motor:
 Check cable routing and temperature.
 Can abnormal running noise be heard?
Check bearings.
 Check cooling fins and air intakes.
Monthly Drive pulley Visual inspection:
 Is the drive pulley soiled? If so, clean the
pulley.
 Is the surface damaged? If so, replace the
pulley.
Monthly Flange bearings Inspection:
 Can abnormal running noise be heard from
bearings? If so, replace bearings.
 Compare bearing temperatures. If one
bearing is at a significantly higher tempera-
ture, replace it.
Monthly Bearings of belt edge
holders
Inspection:
 Can abnormal running noise be heard from
bearings? If so, replace belt edge holders.
 Is an excessive amount of lubrication
coming out of the bearings? If so, replace
belt edge holders.
Every 6
months
Joining elements Check the screws subject to dynamic load for
firm seating.