Transportation and installation
Final installation on-site
44
Operating instructions: Indexing conveyor/short track conveyor TS 1300
Version 3.6ENG, 28.02.2019
Mounting the side guides
Your conveyor is delivered with side guides depending on the scope of
delivery. Please refer to service specifications for this information.
Complete the following steps:
1. Assemble the side guides.
2. If necessary, mount photoelectric sensors and supports in such a way
that it becomes impossible to reach into the conveyed loads.
3. If the hazard is still present, affix the warning label "Hand injury" to the
side guide next to the hazardous area on the outside making sure that it
is highly visible.
The side guide has been assembled.
To Next Page
Loading...
