Troubleshooting
What to do if...
83
Troubleshooting
This section informs you what to do if a malfunction occurs. A malfunction
that has been detected can have various different causes.
Please refer to the "Maintenance and repair" section for instructions on the
relevant fault clearance steps provided that this work may be carried out by
technical personnel as specified at the start of this document. Please ensure
full compliance with the safety instructions in each section.
What to do if...
Mechanical faults
Fault identified Possible cause Remedial action
Machine shuts down Power supply disrupted,
error message
Have technical personnel
establish the cause and
eliminate the problem
Gear motor defective, warning
message, motor brake blocks -
optional
Have technical personnel
establish the cause and
eliminate the problem,
replace gear motor as
required
Machine shuts down
with motor running
Pulley journal broken Replace corresponding
pulley
Drive pulley slipping Check belt tension,
increase tension as
required. Check friction
lining of pulleys, replace
pulley as required
Abnormal noise from
gear motor
Motor lubrication not sufficient.
Leaks
Check motor oil level, top
up if necessary or
replace motor
Belt moving off to the
sides
Incorrect adjustment Adjust the belt
Heavy single-sided loading Ensure centred loading
Machine soiled Clean machine
Conveyor belt difficult
to adjust, belt bulging
Friction lining of pulley worn Replace pulley
Conveyor belt defective due to
overheating
Replace conveyor belt
To Next Page
Loading...
