transnorm TS 1300 - Page 82

Maintenance and repair
Replacing the drive pulley/tail pulley
82
Operating instructions: Indexing conveyor/short track conveyor TS 1300
Version 3.6ENG, 28.02.2019
 Assemble the gear
motor
Complete the following steps:
 Assembly must be carried out in the reverse order.
 The gear motor has been fitted.
 Tighten/adjust the
belt
Complete the following steps:
 Proceed as described in "Tightening/adjusting the conveyor belt".
 The belt has been tightened/adjusted.
 Assemble the side
guide
Complete the following steps:
 Assembly must be carried out in the reverse order.
 The side guide has been fitted.

The drive pulley/tail pulley have been replaced.